All products Decision layer Data collection Trip Counting Module
Active safety and control
Engine and thermal management

Solutions Tipper trucks and trailers

Tipper truck rules and site safety in Türkiye

Rollover on a slope, driving with the body raised and load spilling onto the road are risks of the same vehicle. MetaDamper stops a risky lift, MetaControl covers the load from the cab and MetaFMS records the interventions.

Tipper truck surrounded by X, Y and Z axes with roll, pitch and yaw arcs; in front, a 6-axis sensor module with gyroscope and accelerometer
5°Default side-slope threshold, adjustable
55°Default combined-angle limit with the Wireless Sensors pack
10 km/hDefault travel-protection threshold, with the 4.3″ display or the Motion Control Module
279Automatic tipper interventions in one period summary, across 81 vehicles
Vehicles covered
  • Vehicle category (UN/EU classification): N2
  • Vehicle category (UN/EU classification): N3
  • Vehicle category (UN/EU classification): O4
  • Tipper truck (earthworks, construction, mining)
  • Tipper trailer and semi-trailer
  • Public and municipal tippers (road maintenance, snow and salt)
  • Open-body trucks carrying aggregate, sand and gravel

What is required for these vehicles?

There is no single “tipper regulation”. Load securing is set by law and excavation-waste haulage by regulation, while tipper safety systems are asked for in public tender specifications (for example DMO). Below we summarise what each rule requires, whom it covers and where it comes from.

Mandatory (law)

Securing the load

A vehicle may not be loaded, without proper lashing and securing, in a way that lets the load touch the road, fall, spill, scatter, leak, flow, slide, make noise, tip over or unbalance the vehicle. The law sets the outcome, not a method.

Applies to
All vehicles carrying a load, including tipper trucks and trailers with bulk loads
Dates
In force since 27 February 2026
For this need

Source: 2918 sayılı Karayolları Trafik Kanunu md. 65/1-h (Turkish Road Traffic Law, Art. 65/1-h, as amended by Law 7574 Art. 18, Official Gazette 27.02.2026/33181)

Mandatory (law)

Covering vehicles that carry excavation and construction waste

To prevent pollution during haulage, the vehicle body must be covered with suitable material, the vehicle may not be loaded above capacity and its wheels must be cleaned before it joins traffic. Carriers need a haulage permit from the municipality within its jurisdiction, or from the highest local civil authority outside it; construction and demolition waste trucks must be yellow and marked “İnşaat/Yıkıntı Atığı Taşıma Aracı”.

Applies to
Vehicles carrying excavation soil and construction or demolition waste
Dates
In force
For this need

Source: Hafriyat Toprağı, İnşaat ve Yıkıntı Atıklarının Kontrolü Yönetmeliği md. 24–25 (Regulation on the Control of Excavation Soil and Construction and Demolition Waste, Arts. 24–25, Official Gazette 18.03.2004/25406)

Public tender specification

Tipper safety system in public tenders (specification example)

A specification clause shown as an example in our product catalogue, stated to belong to purchases by KGM (General Directorate of Highways), asks for a tipper safety system on every truck: side-to-side and front-to-rear slope sensing; a warning and lift inhibit at 6° side slope or more; PTO cut-off above a 45°–55° peak angle; a safe lift angle based on ground slope; automatic lowering above 60°; engine stop on lateral movement above 45°; PTO disabled above 10 km/h and lowering of a body left raised; body and tailgate sensors; and a cab control panel with an LCD of at least 4″ that also shows fault codes. No official copy of the specification could be found in public sources; in each tender, the technical specification of that tender prevails.

Applies to
KGM purchases to which the catalogue example is attributed; the specification's name, date and tender record have not been verified
For this need

Source: Specification example from our catalogue (KGM, “Damper Güvenlik Sistemi” / tipper safety system clause); official copy not verified

Public tender specification

Automatic tarp operated from the cab (unverified example)

The law does not require an automatic tarp; this requirement arises only from the specification of the tender concerned. A public service-procurement technical specification included as an example in our product file asks for a tarp system on the tipper body that can be operated automatically from inside the cab and manually from outside. The tender and decision reference of this example has not been verified, so it should not be read as a general public requirement.

Applies to
Tipper vehicles in the public service tender concerned
For this need

Source: Example of a public service-procurement technical specification; tender and decision reference under legal review

Public tender specification

10 km/h limit while the body is raised

The specification asks for a system that limits road speed to 10 km/h while the body is not fully lowered, and a system that prevents the body from being raised while the vehicle is moving faster than 10 km/h. MetaDamper's motion control (the 4.3″ display or the Motion Control Module) is built for the part that stops the body rising while the vehicle is moving; limiting road speed while the body is raised is not a product function.

Applies to
6–18 m³ tipper trucks bought through DMO (State Supply Office)
Dates
Specification dated 25.07.2017; confirm the current version with DMO
For this need

Source: Devlet Malzeme Ofisi Damperli Kamyon Teknik Şartnamesi (DMO tipper truck technical specification A.24.d/25.07.2017), Art. 1.2.4.1

Mandatory (law)

Tachograph

Motor vehicles used for carrying goods with a maximum laden mass over 3,500 kg must carry and use a tachograph, and tampering with it is prohibited. A tachograph is a separate type-approved device and is not part of Metadiag's product range.

Applies to
Motor vehicles used for carrying goods with a maximum laden mass over 3,500 kg, except those exempted by regulation
Dates
Already mandatory for trucks and tractor units before 2026 (Road Traffic Regulation Art. 64/b, Schedule 1). For other vehicles brought into scope by the new wording in force since 27.02.2026, it is not required until the first roadworthiness inspection after these dates, by model year: 2021 and later 31.12.2026; 2016–2020 31.12.2027; 2011–2015 31.12.2028; 1996–2010 31.12.2029; 1985–1995 31.12.2030. Within municipal and adjacent-area boundaries, for commercial passenger vehicles under Laws 5216 and 5393 and official vehicles used to carry goods or passengers, it is not required for vehicles registered for the first time for one year from 27.02.2026.
Outside the scope of Metadiag products

Source: 2918 sayılı Karayolları Trafik Kanunu md. 31 ve Geçici md. 27 (Turkish Road Traffic Law, Art. 31 and Provisional Art. 27, as amended by Law 7574 Arts. 6 and 34, Official Gazette 27.02.2026/33181)

Where are the risks on a tipper?

Most tipper risks cannot be seen from the cab. As the body rises, the load's centre of gravity rises with it, and a few degrees that do not matter on a flat road become critical with the body up. Between site and road, an open body and a body left raised create risks of their own.

Tipper with its body raised on a slope; the lift is locked, with the MetaDamper unit and risk, block and safety steps beside it

Rollover on sloping or soft ground

When the body is raised on uneven ground, the load leans towards the slope. Loose fill gives way and a wheel sinks; with the body up, a few degrees of side tilt can start a rollover.

With MetadiagMetaDamper measures side and front-to-rear slope continuously. When the default 5° side or 13° front-to-rear threshold is exceeded, it warns, stops the lift and lowers the body.

Metadiag body sensor and tailgate sensor side by side on a dark navy background

Tailgate that does not open

If the body is raised before the tailgate opens, the load does not discharge, the weight gathers at the rear and the truck can rear up. The risk grows when the tipping point is at the edge of a bank.

With MetadiagThe tailgate and body sensors in the Wireless Sensors pack do not allow lifting before the tailgate opens. The combined angle is limited to 55° and the backward-tipping lock engages.

A tipper with its body raised and the same tipper with the body down after automatic lowering; the MetaDamper unit above

Body left raised on the road

When the body is left raised or the control lever is touched by mistake, the truck can strike an overpass, a bridge or a power line.

With MetadiagTravel protection, which comes with the 4.3″ display or the Motion Control Module, prevents the body from rising while the vehicle is moving and lowers a body left raised. The default threshold is 10 km/h and can be adjusted at installation.

Yellow automatic tarp gathered on its support bows on top of a tipper body

Load spilling onto the road

Sand, gravel and excavated soil blow out of an open body with vibration and wind. With manual covering, the driver climbs onto the body every trip; when covering is skipped, the load ends up on the road.

With MetadiagMetaControl opens and closes the tarp from the cab panel or by remote control with a range of up to 50 m. The driver stays off the body, and the motor stops by itself when the tarp is fully open or closed.

MetaFMS tipper save list: time-stamped dangerous angle entries, driver names hidden

Interventions that go unrecorded

A risky lift on site rarely reaches the manager. Without knowing which vehicle, which driver and how often an intervention was needed, training and safety measures rely on guesswork.

With MetadiagMetaDamper writes each intervention to its black box; with the 4.3″ Display pack, records are sent to MetaFMS. The panel lists time, intervention type and driver for each vehicle.

Frequently asked questions

Is a tarp mandatory on a tipper truck?

Turkish law requires safe load transport, rather than a particular tarp type or an automatic tarp; Article 65/1-h of the Road Traffic Law prohibits loading that can fall, spill or scatter without proper securing. Excavation and construction waste vehicles must be covered with suitable material. See covering excavation and waste loads. MetaControl automatic tipper sheeting covers the load from the cab.

What is the tipper safety system asked for in public tenders?

The DMO (State Supply Office) tipper truck specification (clause 1.2.4.1) asks for systems that limit road speed to 10 km/h while the body is not fully lowered and prevent the body from being raised above 10 km/h. A specification clause shown as an example in our product catalogue, stated to belong to KGM purchases, describes a system made up of slope sensing, lift inhibit, automatic lowering, engine stop, travel protection, body and tailgate sensors and a cab display; its official copy has not yet been verified. For the DMO part that stops the body rising while the vehicle is moving, MetaDamper motion control (the 4.3″ display or the Motion Control Module) is built for this need; limiting road speed while the body is raised is not a product function. For the slope sensing, lift inhibit, automatic lowering, travel protection, sensor and display items of the catalogue example clause, the Standard Module, Wireless Sensors and 4.3″ Display packs are built to work together. For each tender, our technical team matches the specification clauses one by one before the bid. See tipper safety systems in Turkish public tenders.

Can MetaDamper be fitted to existing trucks and trailers?

Yes, MetaDamper can be fitted to existing trucks and trailers. On air-operated tippers, the coil and valve set cuts lifting air and triggers lowering; the lowering trigger is wired directly on vehicles with electric lowering. The Standard Module includes the trailer link cable and socket; the tailgate sensor is not recommended for chain-operated or manual tailgates.

Is a tachograph mandatory on a tipper truck?

Under Article 31 of the Road Traffic Law, goods vehicles over 3,500 kg must have a tachograph; for trucks and tractor units this was already mandatory before the amendment of 27.02.2026 (Road Traffic Regulation Art. 64/b, Schedule 1). For other vehicles brought into scope by the new wording, it is not required until the first inspection after a date between 31.12.2026 and 31.12.2030, depending on the model year. A tachograph is a separate type-approved device and is not part of Metadiag's product range.

Where can tipper interventions be seen?

MetaDamper records interventions in its black box; with the 4.3″ Display pack, records reach MetaFMS fleet management software. The panel lists the time, intervention type and driver for each vehicle. MetaControl works on the vehicle and is not shown in the panel.

Tipper trucks and trailers

Let's start with a few pilot vehicles in your fleet

Tell us how many vehicles you run and how you use them, and we will work out the right product set and installation plan with you.

Products of interest